Skip to content
Vilekeguast StudioKnife sharpening
Water stones, guided angles, and careful deburring—each blade leaves with grit n

Sharpening desk

Edges refined so cuts stay quiet and controlled

  • Kitchen knives
  • Edge geometry
  • Steel care

Water stones, guided angles, and careful deburring—each blade leaves with grit notes and a strop card, not a mystery machine pass.

Named pieces

Recent work from the bench — each piece is titled so you can reference it when you book.

A chef knife with a refined primary bevel and clean strop finish.

Chef Primary Edge

A chef knife with a refined primary bevel and clean strop finish.

Two petty knives with matched angles for board work.

Petty Pair

Two petty knives with matched angles for board work.

A heavy cleaver with restored geometry after chip repair.

Cleaver Reset

A heavy cleaver with restored geometry after chip repair.

Studio rates

Indicative prices before custom additions.

Chef knifePrimary reset and polishKč 420
CleaverGeometry restore and stropKč 560
Three-knife setMatched kitchen setKč 990
“The chef knife sliced tomato skins cleanly after the reset without the dragging feel it had before.”

— Return client

Common questions

How long for a kitchen set?

Most three-knife sets return in 3–5 days after intake photos and steel notes.

Do you sharpen serrated bread knives?

Limited serration work only; deep gullets may be refused.

Can you match a factory angle?

We aim close; damaged edges may need a new geometry plan.

How a commission moves

Numbered studio verbs from first measure to handoff.

01. Inspect

We check chips, warps, and prior angles before any stone touches steel.

02. Set

Primary bevels are set on coarse stones with angle guides noted.

03. Refine

Progressive grits refine the edge; burs are tracked under light.

04. Strop

Leather strop and compound polish the edge before handoff.

Studio entrance for appointments

Visit the bench

Appointments keep the workspace clear. Walk-ins are rare; send a request and we confirm a slot by email.

Jánská 12, 602 00 Brno

Wed–Sat 11:00–19:00

Same-week openings are confirmed by email after you send the booking form.

Visit page

Materials and pacing

Clients often arrive with a dull chef knife and a question about how thin the edge should feel. We answer with stone samples and a light check first, then a clear day count.

The desk keeps reference angles so you can see geometry before we grind. That single check settles debates faster than a vague request for razor sharp.

We write down which grit sequence you approved and which aggressive thinning we refused so the finished edge matches the honest plan.

Appointments are paced so stones stay flat between visits. If a slot is full, we offer the next open window rather than rushing a bevel that overheats.

Care notes travel with every handoff: strop frequency, board habits, and when to return if a chip appears later.

Seasonal kitchen humidity shifts how carbon steel spots after sharpening. Bring a note about storage; wet blocks alone can push care advice that feels different at home.

We do not promise awards or viral finishes. We promise measured angles, named steps, and a reply when your message lands in the booking form.

If you are gifting a sharpened set, tell us the handoff date early. Blade guards and wrap cards are prepared after the last strop, not before the burs are gone.